So here she is on my guest room ceiling:
This is how I did it.
I took this fixture from my parent's house when they were swapping out lights. It is actually really common and this base was hidden by an ugly stain glass bowl.
I liked the simple sputnik like arms and I knew it had hacking potential so it went to the hoard.
After many failed attempts with styrofoam balls I turned to Sculpey clay.
(any clay you can bake to harden will work)
This is also good for making little urchin sculptures.
I rolled out a ball the size of an apple:
cut it in half:
jammed a pencil through both sides:
I took my fixture apart and jammed the center rods through:
Then I took wooden kabob skewers in various lengths (the kind you find in a grocery store) and jammed them into the lower half portion of the light...
(lots of jamming going on)
this is the part you will see from the bottom when you will be looking up at the light:
I pulled all the skewers out:
and started doing the same thing for the upper half.
Make sure when you do this upper half you leave clearance for the ceiling and light bulbs
(if they are close).
Once you are done, pull the skewers and bake them on the rods for time listed on the package.
Mine was 45 minutes at 275 degrees.
I then sprayed the skewers gold:
Let the clay cool, and then spray that too.
Reassemble your fixture.
You can start reinserting your skewers, but I found it easier to do once the fixture was installed.
I dipped the end of the skewer in Liquid Nails before inserting it into the dry clay center.
I slide the lower clay half up the rod closer to the bulbs and affixed with glue.
(Use tape to hold in place and keep from sliding down until dry.
Then BAM!
My cheap Brass Urchin Light.
I will keep you posted on how well it hold together
and take some better pictures of the room once it's done.
(remember, this is the junk drawer room- so below this light is pretty horrifying)
Happy Weekend!
