What you will need:
1 sheet of red card stock 2 sheets of white card stock Ruler Glue stick Craft knife Velcro {optional}
Download the below PDFs; the first page on red card stock{the red outer card}, and the last two on white card stock.
Using a craft knife and a ruler, cut along all the dotted lines on all 3 sheets.
Score along the remaining solid lines of each of the three pieces. The scored lines will be on the interior of the shadowbox and will not be seen.
Fold the outer red card cover with the printed lines towards the inside. The larger rectangle tab should be on the outside and glued over the smaller tab.
Tip: Personalize your card further by writing a message along the inside of the red cover. If you choose to write a message like I did, close the cover using velcro strips instead of glue so your card will be able to open and close.
Place the smallest white section {folded sides facing down} inside the right side of the larger white piece. Add a little glue to the left and right tabs of the small white piece {do not add glue to the top and bottom 1/4″ of each side- leave it glue free as the tabs from the larger white piece will need to be glued into it.} Add glue to the outside of the right side tab of the large white piece. Close the box and press all sides that have glue. The right side tab of the large piece of white paper should be tucked under the larger rectangle tab from the opposite side. Close the top and bottom, adding glue to all the tabs. The tabs should slide in between the inner and outer pieces of paper.
You can also cut out a small red heart by hand and attach it to the tree trunk in the center of the card (and personalize it with your initials!)