At work today, I spent a lot of time thinking about how I haven’t done a video for over one month now; how much I want to make the most of what time I have left in my workshop; how I need to crack on and finish the mobile base I started for my table saw, weeks ago… All whilst banging nail after nail in to small sheets of wavy birch plywood!
So, I was home by 17.00 and, after briefly stopping in the bathroom, I grabbed my camera and headed straight out to the workshop! Evenings have been almost mild this week (even though forecasters are now forewarning the threat of snow to follow this weekend – just when we were opening our arms to welcome the spring!). In two hours, I managed to get the following filmed and also, I made some good progress on the mobile base, which I’ll share with you another time.
This is something that I originally intended to film and publish about a month ago during Get Woodworking Week… I also have a ‘Valentine’s Gift’ idea that I’d like to film at some point but, it looks like I’m going to sail straight past Mother’s Day with that one as well! This video’s all about cutting a tee-halving joint, which is a traditional form of lap-joint, between two pieces at 90°.
I hope you enjoy the video. I’m incredibly nervous and fast-talking infront of the camera but I welcome all and any comments people may have. It takes a good hour for me to upload a video of this length and I do now try to keep them brief… That also means compromising a little on the finished quality but then, I’m only using Windows Movie Maker, which is a free program.
If I was to use something paid-for (like Camtasia), would I able to experience faster upload speeds?
Ideally, I’d like to have one short video to upload once each week. In fact, from the video I’m sharing with you this evening, I could easily have cut a section from the end and published that under its own heading.
Thanks both for reading and for watching!
51.455313 -2.591902